Fig.1 is the plan of the well and the steps, landing and starting, at the half-space landing. The lines marked CS are the direction of the cuts to be made through the circular or well string for the risers to mitre to.

Fig.2 shows a piece of thin stuff cut to a semicircle to fit the inside of the string. This piece is laid on the plan, and the position and direction of the cuts for risers is marked on it as seen by CC.

Fig.3 shows a section of a staved well, the joints being ploughed out and cross tongues put in as shown. Each joint must be well glued and rubbed and screwed through the back. It will be noticed it is carried past the springing into the straight on both sides; this makes a better job, as a joint made in the springing always has a crippled appearance, no matter how well the job may be done.

Fig.4 shows a falling mould for marking the treads and risers, also the bottom edge of the well in a continuous line with the bottom edge of the two straight strings. Take a thin lath and bend it around Fig.2, and mark on it the springing and risers, as shown by SS and RR. Lay this lath on the piece of stuff the falling mould is to be cut out of, in a horizontal position, as shown, and mark the risers and springing. Set up a step above and below the springings, and set off SS to equal SS, Fig.2, PlateVIII. Then draw the under side of straight strings and continue it across the well, taking care to have the best possible falling line. HH shows the length the pieces forming the well will require to be. This falling mould may be made out of good stiff brown paper, or any other suitable stuff. Now bend it around on the inside of the well, and mark the treads and risers and the bottom edge. Keep the springing lines on the mould to the springing marked on the well. To mark the springing on the well take Fig.2 and hold in the well, and mark the springing top and bottom and finish it with a straight edge. Also mark the direction of the cuts as shown by the lines marked C.

Fig.5 shows how the well is fixed to the straight strings. This must be all fitted in the shop ready to slide up in its place when the stairs are fixed, when it should be well glued, wedged and screwed. The circular string for the starting and top landing of Fig.1, PlateVII., may be got out and fixed in the same way. These kind of wells answer the purpose for which they are used, but they are not so strong as a veneered well, which is shown on PlateXI.

Fig.6 shows the step starting from the half-space landing. This step is slightly curved at the end to make it the same width on the end as the rest. The risers, starting and landing are laid down to suit the rail, as shown in PlateXVII.

Fig.7 shows the return nosing for this step.

Fig.8 shows the landing step. This is got out long enough to reach from wall to wall. This step is glued up in the shop with the rest; the nosing is worked on the solid and returned as far as E, about 2 or 3 inches on. The scotia is fixed around the circular part after all is fixed.

Fig.9 shows the top landing step. This too goes from wall to wall, and is treated in the same way as Fig.8, only the nosing is worked from end to end.