A. A. Stewart

The width of a type page is called its measure. Before commencing to set type the stick must be set to the measure required; that is, for the length of the type line. If the stick is of the modern graduated pattern which sets to standard measures by changing the movable side-piece to a slot or notch where it is fixed, the setting is a simpler matter. These sticks will no doubt be in more common use later than they are now because of their many advantages; but as there are many of the old style thumbscrew sticks (especially the kind known as the Yankee job stick) in use in composing rooms throughout the country, it is necessary to know how to adjust these correctly. The old style sticks not only require care in setting but watchfulness afterward to see that they do not change while being used for a job.

The manner of setting a stick may depend upon the kind of work to be done. For job work of a few lines only, where the lines are to be locked by themselves in a chase, the stick may be set by a bunch of leads of the required length. These are placed in the stick and the movable knee set up to them loosely, so that the leads do not bind at the ends. If the job is to be enclosed in a border or rule panel the stick should be adjusted accurately to ems of 12-point or 6-point.

Fig.5

For ordinary measures a line of perfect 12-point quads will be a good gage. For very short measures, as in tabular column heads, 6-point quads should be used. A gage that will be more uniformly accurate is a line of 12-point letters (for short measures) or 24-point letters (for longer measures) from a font of foundry-cast type. These should be set in the stick with the nicks sideways, not in front as for composition. The body-size of cast type is the most accurate of any point-size material, and as 12-point and 24-point fonts are at hand in every composing room they furnish a convenient and reliable standard at all times.

Usually the knee should be set lightly against the gage when the thumbscrew is tightened. A good plan is to put a slip of paper at one end of the line of quads or letters (See A, Fig.5), and to push up the knee firmly. A line of many separate types will not fit together as solidly as a line of a few quads; to allow for a little compression in the line when it is locked up later the slight fullness is given in setting the stick. In setting measures for tabular columns and for very short lines the slip of paper is not necessary.

It is important that the outer end of the knee should be kept at a right angle to make the stick square, in order that the first and last lines of the stickful should be of exactly the same length. If there is any doubt about this, test the front of the stick by moving the gage line forward when the measure is adjusted. If the gage line is looser here than at the back, the outer end of the knee may be closed in by inserting a piece of card between the knee and the back plate, as is shown at A in Fig.6.

When the measure is set, make the thumbscrew as tight as possible with the fingers. Do not use a wrench, as this is liable to give unnecessary force and break the small clamp.

Make it a practice to try the thumbscrew occasionally while using the stick to prevent the knee from becoming loose, as it may in case the lines are justified tightly.