A CRANE

Previous

Materials Required:—

A wooden sweet box, three large reels, one small one, tacks, upholstery nails, string, mucilage, a fret saw, a large coat hook.

Fig. 83.

This should also be made of a box of soft wood from the grocer. The semicircular sides should be about four inches long, where they are fastened to the base; they may either be glued or nailed on to this. The base should be about seven inches long and three inches wide. Before fastening on the side-pieces bore a hole at the end of each to insert the thick wire which turns the large reel used to wind the cord, and also set in the tacks which support the crane at each side. The sides of the crane should be about three quarters of an inch wide at the lower end, and should taper to about half an inch at the other end; they should be about seven inches long. Near the lower end use another smaller reel or a block of wood as a stay to hold the sides of the crane; it should be of such a size as to hold the ends of the crane firmly between the nails in the sides of the base. At the other end set in a very small reel, with a long slim nail, so that it will easily turn on it. Now take a good strong dressmaker's hook, such as is used for coats or mantles, fasten it to a length of strong string, and wind one end round the large reel, setting the hook end over the end of the crane.


                                                                                                                                                                                                                                                                                                           

Clyx.com


Top of Page
Top of Page